Welcome to www.waterfillingmachine.com

WT-RO-3000 Prefilter and Reverse Osmosis

» WATER PURIFICATION » WT-RO-3000 Prefilter and Reverse Osmosis

WT-RO-3000 Prefilter and Reverse Osmosis

CATEGORY AND TAGS:
WATER PURIFICATION
enquiry
  • Specifications
  • Key Features
Technical Specifications
Model No WT-RO-3000
Capacity 3000LPH(Liter per Hour)
Nominal Recovery 65-75%
Nominal Salt Rejection 99.60%
Operating Temperature 15°C-45°C
Design Temperature 25°C
Feed Pump 1.1KW
High Pressure Pump 3.0KW
Voltage 220V /380V/460V – 50Hz/60Hz
WT-RO-3000 Prefilter and Reverse Osmosis
WT-RO-3000 pre-filter and reverse osmosis is has been engineered to treat raw water from ground and surface to be drinkable water. It has ability to produce 3000 liters purified water per hour and built with heavy duty stainless steel 304, pre filters and reverse osmosis are mounted on frame for easy installation, HYDRANAUTICS membranes are used, Critical electronic components are world famous brand. Complete set includes pre-fitlers and reverse osmosis system. There are more than one pre-filter used in a Reverse Osmosis system, the most common being sand and carbon filters. These pre-filters are used to protect the RO membranes by removing sand silt, dirt, and other sediment that could clog the system. Additionally, carbon filter is used to remove taste, odor, organic contaminants, and chlorine, which can damage the RO membranes, Water softening is the reduction of the concentration of calcium, magnesium, and certain other metals in hard water, Cartridge filters, almost universally used in all RO systems prior to the high pressure pump, serve as the final barrier to water born particles. The nominal rating commonly used in RO applications is in the range of 5 - 15 microns. Reverse osmosis (RO) is a membrane-technology filtration method that removes many types of large molecules and ions from solutions by applying pressure to the solution when it is on one side of a selective membrane. The result is that the solute is retained on the pressurized side of the membrane and the pure water is allowed to pass to the other side. To be “selective,” this membrane should not allow large molecules or ions through the pores (holes), but should allow smaller components of the solution (such as the pure water) to pass freely.
Technical route and flow diagram instructions
Raw water tank → Booster pump → Sand filter → Activated carbon filter → Softener Micro filter
→ High pressure pump → Reverse osmosis → Permeate tank
Key Features
Materials of Construction
Skid Frame: SS304
Membrane Elements:Hydraulics CAP3-LD
Membrane Housings: SS304
Low pressure piping: SS304
High pressure piping: SS304
Pump and Motor
Pump: 304SS vertical multi-stage centrifugal
Motor: TEFC, 380/460 VAC, 3-phase, 50/60 Hz.
Standard Features
8” x 40” High rejection membrane elements
5-micron sediment pre-filter housing
Automatic inlet solenoid valve
PLC control
Product water conductivity monitor
Operating pressure gauges
Product and concentrate flow meters
Concentrate and recycle flow control valves
Low inlet pressure switch with shutdown alarm
Auto/Manual wash
Optional Equipment Available
Atmospheric storage tanks with level control and repressurization pump
Pressurized storage vessels
UV
Ozone generator
Membrane clean-in-place (CIP) systems
Pretreatment chemical injection systems

Enquiry Form ( we will get back you as soon as possible )

Name:
*
Email:
*
Message:

Verification:
5 + 3 = ?

Maybe you like also