Welcome to www.waterfillingmachine.com

WT-RO-2000 Water Treatment and Reverse Osmosis

» WATER PURIFICATION » WT-RO-2000 Water Treatment and Reverse Osmosis

WT-RO-2000 Water Treatment and Reverse Osmosis

  • Specifications
  • Key Features

Technical Specifications

Model No WT-RO-2000
Capacity 2000LPH(Liter per Hour)
Nominal Recovery 65-75%
Nominal Salt Rejection 99.60%
Operating Temperature 15°C-45°C
Design Temperature 25°C
Feed Pump 0.75KW
High Pressure Pump 2.20KW
Voltage 220V /380V/460V – 50Hz/60Hz
WT-RO-2000 Water Treatment and Reverse Osmosis
WT-RO-2000 water treatment and reverse osmosis system has been designed to turn raw water from ground or surface water into safe drinking water, capacity of 2000 liters per hour can be achieved, consisting of a sand filter to remove particulates, turbidity, sand and rust, an activated carbon filter to remove the chlorine, pesticides, herbicides, disinfectants, and VOCs which might otherwise damage the reverse osmosis membrane, a water softener to reduce hardness of water, a micro filter is required as a last step before the RO membranes to prevent any debris, sand particles or piping material to damage the membranes. The reverse osmosis process uses a semi-permeable membrane to separate and remove dissolved solids, organics, pyrogens, submicron collodial matter, viruses, and bacteria from water. The process is called "Reverse" Osmosis since it requires pressure to force pure water across a membrane, leaving the impurities behind. Reverse osmosis is capable of removing 95 - 99% of the total dissolved solids (TDS) and 99% of all bacteria, thus providing safe, pure water.
Technical route and flow diagram instructions
Raw water tank → Booster pump → Sand filter → Activated carbon filter → Softener Micro filter
→ High pressure pump → Reverse osmosis → Permeate tank
Key Features
Materials of Construction
Skid Frame: SS304
Membrane Elements:Hydraulics ESPA2-4040
Membrane Housings: SS304
Low pressure piping: SS304
High pressure piping: SS304
Pump and Motor
Pump: 304SS vertical multi-stage centrifugal
Motor: TEFC, 380/460 VAC, 3-phase, 50/60 Hz.
Standard Features
4” x 40” High rejection membrane elements
5-micron sediment pre-filter housing
Automatic inlet solenoid valve
PLC control
Product water conductivity monitor
Operating pressure gauges
Product and concentrate flow meters
Concentrate and recycle flow control valves
Low inlet pressure switch with shutdown alarm
Auto/Manual wash
Optional Equipment Available
Atmospheric storage tanks with level control and repressurization pump
Pressurized storage vessels
Ozone generator
Membrane clean-in-place (CIP) systems
Pretreatment chemical injection systems

Enquiry Form ( we will get back you as soon as possible )


0 + 5 = ?

Maybe you like also